基于动态补偿的多电机控制算法

多电机协调控制达到转速一致是电机控制中的一个关键难题，外加负载变动和电机参数变化时会引起电机性能的下降，达不到良好的控制效果。为使电机间保持转速同步，建立了永磁同步电机d-q坐标系下的矢量控制数学模型，基于转速跟随控制，提出一种基于单神经元PID的变增益速度补偿器进行偏差耦合控制。在MATLAB/Simulink建立了3台永磁同步电机的仿真模型。仿真结果表明，与传统PID固定增益速度补偿器算法相比，单神经元PID的变增益速度补偿器具有更强的鲁棒性以及更快的收敛性。     

酚醛树脂基纳米多孔材料的制备及结构调控

酚醛树脂基纳米多孔材料（Phenolic Resin-based Nanoporous Materials，PNM）是满足新一代航天飞行器轻质、高效隔热需求的新型热防护材料，传统制备方法中需使用超临界干燥技术，制备周期长、成本高。本研究通过两步法，即先合成线性酚醛树脂，再进行溶胶-凝胶的方法，实现了常压干燥PNM的制备。系统研究了固化剂含量、固化温度和固化时间对材料结构的影响和调控作用，分析了影响材料收缩率和热稳定性的因素。结果表明，PNM的微观纳米结构的变化会影响材料干燥后的收缩率，制备大颗粒、大孔径的微观结构更有利于降低材料的收缩率。而PNM的热稳定性主要受交联反应过程形成的化学结构的影响，通过优化固化剂的含量可提高PNM的热稳定性。当固化剂含量为10%，固化温度提高至150℃，固化时间延长至48 h的条件下，获得的PNM有最高的热稳定性（900℃下的残碳率为54.2%）、最发达的孔结构（比表面积为264.0 m²/g、孔容为2.67 cm³/g、平均孔径为40.0 nm）和最小的收缩率（0%）。此PNM制备方法简单、性能优异，在未来航天飞行器上有广阔的应用前景。     

基于最小约束系统的分布式协作定位研究

5G移动通信系统中,设备到设备的通信方式产生了节点间的信号测量,可用于提升无线定位的覆盖范围和定位精度。提出了一种基于最小约束系统的分布式协作定位方法,该方法首先利用已有算法估计节点参考位置,并据此构建最小约束确定网络的位置及朝向,然后在该约束下极大化由节点间测量引出的似然函数,获得位置估计。理论研究表明,该方法将由节点间测量确定的相对位置拟合到参考位置处,在参考位置等于真实位置时达到最优效果。仿真结果表明,该方法可有效提高定位精度,并具有分布式和可扩展等优点。     

航天器姿态预设性能控制方法综述

针对存在不确定惯量矩阵及其它未知不确定性(如执行器故障、航天器结构发生突变等)下的航天器姿态控制问题，综述了预设性能控制及其应用的研究进展。首先阐释了预设性能控制方法的基本内涵及其关键步骤；然后分析总结了现有航天器姿态控制以及预设性能控制研究的基本概况与发展趋势；最后面向未来复杂化、智能化的空间任务对航天器控制系统提出的新需求，提出航天器预设性能控制值得研究的问题和方向。     

考虑局部遮挡的太阳能无人机能源控制

针对太阳能无人机在飞行状态下可能出现的太阳能电池局部遮挡情况，开展相应的太阳能电池最大功率点追踪算法和能源控制研究。通过将发光亮度引入相对吸引力计算过程对萤火虫算法进行改进，实现了局部阴影情况下太阳能电池最大功率点的高效追踪。以此为基础，设计了考虑局部遮挡情况下太阳能无人机的太阳能电池/蓄电池混合能源状态机控制规则。以"蒲公英I"无人机为例，建立了太阳能电池阵列模型，开展了考虑局部遮挡情况下太阳能电池最大功率点追踪仿真实验；基于"蒲公英I"飞行剖面，开展了考虑局部遮挡情况的混合能源控制仿真试验。研究结果表明：改进的萤火虫算法可以实现在局部阴影情况下太阳能电池最大功率点的有效跟踪，与萤火虫算法相比收敛时间更短、且功率波动幅度更小；采用改进萤火虫算法和状态机能源管理策略，在考虑局部遮挡的飞行状态下可以实现太阳能电池/蓄电池之间的合理功率分配与控制。     

Backstepping sliding-mode control of stratospheric airships using disturbance-observer

In the presence of unknown disturbances and model parameter uncertainties, this paper develop a nonlinear backstepping sliding-mode controller (BSMC) for trajectory tracking control of a stratospheric airship using a disturbance-observer (DO). Compared with the conventional sliding mode surface (SMS) constructed by a linear combination of the errors, the new SMS manifold is selected as the last back-step error to improve independence of the adjustment of the controller gains. Furthermore, a nonlinear disturbance-observer is designed to process unknown disturbance inputs and improve the BSMC performances. The closed-loop system of trajectory tracking control plant is proved to be globally asymptotically stable by using Lyapunov theory. By comparing with traditional backstepping control and SMC design, the results obtained demonstrate the capacity of the airship to execute a realistic trajectory tracking mission, even in the presence of unknown disturbances, and aerodynamic coefficient uncertainties.     

A novel architecture of electro-hydrostatic actuator with digital distribution

To address the flow imbalance rapidly of the asymmetric Electro-Hydrostatic Actuator (EHA), this paper presents a novel architecture of asymmetric EHA with the Digital Distribution (EHA-DD). It also improves the flow nonlinearity and control accuracy of the pump, especially in the low-speed condition. The digital distribution with two High-Speed on–off Valves (HSVs) not only balances flow instead of the check valves, but also replaces the pump at the low-speed to control output flow by adjusting the PWM signal. The pump and HSVs are the crucial components to control flow output. Firstly, the flow calculation models of the pump and the duty ratio inversed model of the HSV are obtained through experimental tests and the identification method. To get the control input signal for the required flow, the pump speed and PWM duty ratio for the HSVs are inversed to compensate for flow output. Further, a multimode digital flow distribution control method based on pump speed, mainly including the pump-controlled mode for large flow demand and valve-controlled mode for little flow demand, is proposed to control the accurate flow output actively. The step extension experiments based on the flow calculation models are conducted on the EHA-DD prototype under elastic, opposite varying load. The results demonstrate that the EHA-DD realizes little position error by accurate flow control, and it is also beneficial to improve the service life of the pump.     

轨控大干扰下的系统角动量管理

摘要： 针对利用角动量交换装置系统实现轨控期间姿态维持的情况，研究当轨控推力器存在大力矩扰动时系统角动量管理方法.结合对地运行航天器轨道运动特性，分析轨控干扰力矩的积累角动量变化规律；考虑角动量管理装置系统的角动量存贮容量，基于角动量积累规律提出了一种结合偏置角动量建立与对称分布轨控位置选择的系统角动量管理方法，实现了对称轨控位置积累角动量互相抵消的自平衡效果，极大程度地提高轨控效率且避免系统角动量饱和现象.所提出的方法适用于喷气欠驱动控制系统，方法的有效性通过了数学仿真验证及在轨型号应用.     

利用微波探测仪(ATMS)对在轨微波辐射计观测精度的模拟分析

微波辐射计的观测精度及其对数值模式同化应用的影响评估是微波辐射计观测指标设计的重要参考。基于微波探测仪(ATMS)资料,利用三维变分同化系统模拟分析在轨微波辐射计的观测精度指标。针对ATMS观测误差特征,在其观测基础上增加均值为零、标准偏差分别为0.5,1.0,1.5,2.0K的正态随机扰动,进而获得不同精度的观测模拟值序列,然后利用Harris和Kelley的辐射资料偏差订正经验方法订正不同精度的观测资料。偏差订正后,利用三维变分同化模式(WRFDA)直接同化ATMS资料。通过2016年6月6h预报场的同化试验,评估了不同观测精度的模拟资料对数值模式的同化影响。     

Fault mode probability factor based fault-tolerant control for dissimilar redundant actuation system

This paper presents a Fault Mode Probability Factor (FMPF) based Fault-Tolerant Control (FTC) strategy for multiple faults of Dissimilar Redundant Actuation System (DRAS) composed of Hydraulic Actuator (HA) and Electro-Hydrostatic Actuator (EHA). The long-term service and severe working conditions can result in multiple gradual faults which can ultimately degrade the system performance, resulting in the system model drift into the fault state characterized with parameter uncertainty. The paper proposes to address this problem by using the historical statistics of the multiple gradual faults and the proposed FMPF to amend the system model with parameter uncertainty. To balance the system model precision and computation time, a Moving Window (MW) method is used to determine the applied historical statistics. The FMPF based FTC strategy is developed for the amended system model where the system estimation and Linear Quadratic Regulator (LQR) are updated at the end of system sampling period. The simulations of DRAS system subjected to multiple faults have been performed and the results indicate the effectiveness of the proposed approach.